2020, 08 August |
DOI: 10.14489/td.2020.08.pp.030-043 Belovolov M. I., Kozelskaya S. O., Budadin O. N., Kutyurin V. Yu. Abstract. An analytical review of physically possible methods and available achievements in registering hydrostatic pressure or mechanical stresses using fiber optic fibers and sensors based on them based on published works that can be used in harsh environmental conditions is carried out. The results of the review show that fully distributed or quasidistributed fiber-optic systems for recording hydrostatic pressure or mechanical stress can be implemented on the following physical principles and apparatus with measures to compensate or suppress the influence of temperature: polarizing sensors on birefringent single- mode light guides and OTDR equipment; micro-flexible sensors with OTDR equipment on conventional multimode fibers; measuring systems on fiber Bragg gratings; on discrete sensors, in particular, on sealed fiber Fabry–Perot interferometers; Brillouin distributed sensors on single-mode fibers that are not sensitive to temperature changes. It is shown that single-mode birefringent fibers with hollow holes in the shell and fiber Bragg gratings written in the core have a good linear sensitivity to hydrostatic pressure and a weak dependence on temperature. Lattices in phosphorous-containing single-mode light guides have increased high-temperature properties up to ~500 C and higher. A number of discrete fiber sensors’ structures and pressure recorders are investigated. Various structures of sensitive elements of pressure sensors on sealed fiber Fabry–Perot interferometers and fiber gratings in spherical and cylindrical small-sized cases are investigated. Sensors based on Fabry–Perot fiber interferometers soldered into a glass capillary and protected from water by external high-temperature hermetic coatings showed good linearity in the pressure range of 0…540 ATM at temperatures up to ~200 C. The sensors are efficient at temperatures up to 600 °C and are promising for use in severe and special external conditions. The possibility of compensating the temperature sensitivity by selecting external coatings is shown. Pressure sensors were tested on local areas with microbends and it was shown that they can measure pressures up to ~24 МPа at temperatures up to ~450 C, but to compensate for the dependence of the readings on temperature, it must be measured by an independent sensor. The possibility of independent and simultaneous measurement of hydrostatic pressure and temperature along a single fiber using spontaneous Brillouin scattering is shown. Pressure is measured by the frequency shift of Brillouin scattering, and temperature by its intensity. The operation of the Brillouin recorder in the pressure range 0…34 MРа is demonstrated. The pressure resolution was ~0,2 МРа. New methods are proposed for detecting Brillouin scattering – a heterodyne signal with a high signal-to-noise ratio and based on frequency modulation of a semiconductor single-frequency distributed feedback laser. The measurement range has been increased by more than 10 km and the coordinate resolution has been increased. The Brillouin scattering method is promising for creating distributed systems for measuring hydrostatic pressure or mechanical stress for severe physical conditions, including temperatures of ≥3000 C. Keywords: mechanical stress, temperature, measurement error, fiber optics, sensors.
M. I. Belovolov (Prokhorov General Physics Institute of the Russian Academy of Sciences, Moscow, Russia) E-mail:
Данный адрес e-mail защищен от спам-ботов, Вам необходимо включить Javascript для его просмотра.
Main directions 1. Rogers A. J. (1991). Distributed opticalfibre sensing. SPIE, Vol. 1511, pp. 2 – 24. Distributed Polarization Sensors 9. Kluth E. L. E., Varnham M. P., Clowers J. R., Kutlik R. (1999). Upgradable sensing systems for the oil and gas industry. SPIE, Vol. 3860, pp. 262 – 272. Micro-bend distributed fiber pressure sensors 14. Lu Xiaoming, Ren Xin, Chen Yubo, Chi Rongsheng. (1991). Research of distributed fiber optic pressure sensor. SPIE, Vol. 1572, pp. 304 – 307. Fiber Bragg Pressure Gauges 16. Qiao X., Fiddy M. (2002). Distributed optical fiber Bragg grating sensor for simultaneous measurement of pressure and temperature in the oil and gas downhole. SPIE, Vol. 4870, pp. 554 – 558. Discrete (point) fiber pressure sensors 24. Qi B., Pickrell G. R., Zhang P. et al. (2002). Fiber optic pressure and temperature sensors for oil down hole application. SPIE, Vol. 4578, pp. 182 – 190. Brillouin reflectometers for measuring pressure 31. Parker T. R., Farhadirousan M., Diatzikis E. et al. (2000). Simultaneous optical fibre distributed measurement of pressure and temperature using noise-initiated Brillouin scattering. 14th International Conference on Optical Fiber Sensors. Venice. SPIE, Vol. 4185, Part 3-23, pp. 772 – 775. Polarimetric and bending pressure sensors 36. Clowes J., Edwards J., Grudinin I. et al. (1999). Low drift fibre optic pressure sensor for oil field downhole monitoring. Electronic Letters, Vol. 35, (11). Temperature Coefficients 41. Priest T. S., Jones K. T., Scelisi G. B., Woolsey G. A. (1997). Thermal coefficients of refractive index and expansion in optical fiber sensing. 12th International Conference on OFS. Technical Digest, Vol. 16, pp. 306 – 309. Additional sources Ad.1. Johnson A., Michelson P. New real-time fiber-optic downhole instrumentation systems designed for permanent installation / Sabeus Sensor Systems Sabeus Sensor System Introduces Ultra-robust, Real-time Pressure-Temperature-Vibration and Real-time Distributed Temperature Sensing Systems. For Immediate Release, pp. 1 – 3. Available at: www.sabeus.com
This article is available in electronic format (PDF). The cost of a single article is 350 rubles. (including VAT 18%). After you place an order within a few days, you will receive following documents to your specified e-mail: account on payment and receipt to pay in the bank. After depositing your payment on our bank account we send you file of the article by e-mail. To order articles please copy the article doi: 10.14489/td.2020.08.pp.030-043 and fill out the
|