Журнал Российского общества по неразрушающему контролю и технической диагностике
The journal of the Russian society for non-destructive testing and technical diagnostic
 
| Русский Русский | English English |
 
Главная
23 | 12 | 2024
2022, 04 April

DOI: 10.14489/td.2022.04.pp.034-039

Meshcheryakov V. N., Kryukov O. V.
FREQUENCY-PARAMETRIC CONTROL SYSTEM OF AN ASYNCHRONOUS ELECTRIC DRIVE WITH AN OBSERVER OF THE ANGLE BETWEEN THE VECTORS OF THE STATOR CURRENT AND THE MAGNETIZATION CURRENT
(pp. 34-39)

Abstract. In industry, especially metallurgy, a large number of previously installed electric drives based on an asynchronous motor with a phase rotor with uneconomical parametric control systems are used, the advantage of which is the possibility of removing part of the sliding energy from the rotor circuit, and the ability to obtain an increased inrush current multiplicity. The use of frequency converters in such an electric drive allows you to adjust the speed of rotation of the stator field and maintain sliding and losses in the rotor circuit at a minimum level. However, when the rotor windings are shorted, the multiplicity of the starting torque decreases. Additional possibilities for maintaining an increased starting torque of an asynchronous motor with a phase rotor with frequency control are provided by the inclusion of a frequency-dependent active-inductive resistance (IR) in the rotor circuit. In this case, the electric drive will be frequency-parametric. Using an observer of the mutual position of the stator and rotor current vectors, working on the basis of processing the measured signals of instantaneous values of the stator and rotor currents, allows you to build a scalar control system with stator current correction, bringing the operation of the electric drive to the mode with minimal losses in the motor windings.

Keywords: frequency-parametric control, asynchronous electric drive, sensorless system, induction resistance, correcting observer of angle calculation.

V. N. Meshcheryakov (Lipetsk State Technical University (LSTU), Lipetsk, Russia) E-mail: Данный адрес e-mail защищен от спам-ботов, Вам необходимо включить Javascript для его просмотра.
O. V. Kryukov (TSN-electro LLC, Nizhny Novgorod, Russia) E-mail: Данный адрес e-mail защищен от спам-ботов, Вам необходимо включить Javascript для его просмотра.

1. Meshcheryakov V. N., Boykov A. I., Murav'ev A. A. et al. (2019). The electric drive on the basis of the induction machine with an induction resistance in the rotor circuit connected through valve elements. Izvestiya SPBGETU LETI, (2), pp. 60 – 66. [in Russian language]
2. Plekhanov M. S. (2016). Model of an asynchronous electric motor with a massive ferromagnetic rotor in the minimum slip mode. Proceedings of the IV All-Russian Youth Forum with international participation: Engineering for space exploration, pp. 66 – 70. Tomsk: Natsional'niy Issledovatel'skiy Tomskiy Politekhnicheskiy universitet. [in Russian language]
3. Makarov V. G. (2010). Parameter identification of three-phase asynchronous motor. Izvestiya vuzov. Problemy energetiki, (3-4), pp. 88 – 101. [in Russian language]
4. Kalachev Yu. N. (2015). Status observers in a vector drive. Moscow: OOO «Gamem». [in Russian language]
5. Bochenkov B. M., Filyushov Yu. P. (2011). Control algorithm that provides the desired combination of energy and dynamic properties of the AC drive. Elektrotekhnika, (6), pp. 53 – 58. [in Russian language]
6. Emel'yanov A. P., Churkin B. A. (2014). Scalar control of an asynchronous squirrelcage motor by the active component of the stator current. Vestnik YuUrGU. Seriya: Energetika, Vol. 14, (3), pp. 85 – 90. [in Russian language]
7. Afanas'ev K. S., Glazyrin A. S. (2012). Identification of the speed of an asynchronous electric motor of a laboratory bench using the Kalman filter and the Luenberger observer. Elektrotekhnicheskie kompleksy i sistemy upravleniya, (4), pp. 66 – 69. [in Russian language]
8. Kryukov O. V. (2005). Fast walsh transformation algorithms in microprocessor drive control systems. Izvestiya vuzov. Elektromekhanika, (4), pp. 39 – 44. [in Russian language]
9. Mishchenko V. A. (2007). Prospects for the development of vector control of electric drives. V International (XVI All-Russian) conference on automated electric drives. AEP-2007, pp. 60 – 63. Saint Petersburg. [in Russian language]
10. Kryukov O. V., Meshcheryakov V. N. (Eds.), Sychev M. N. et al. (2022). AC smart drive systems with relay controllers and adaptive corrective devices. Moscow– Vologda: Infra-Inzheneriya. [in Russian language]
11. Simakov G. M., Filyushov Yu. P. (2017). Comparative evaluation of the operation of an asynchronous machine under conditions of minimizing reactive power. Elektro-tekhnika, (2), pp. 8 – 15. [in Russian language]
12. Vygodskiy M. Ya. (2006). Handbook of higher mathematics. Moscow: AST: Astrel'. [in Russian language]

This article  is available in electronic format (PDF).

The cost of a single article is 500 rubles. (including VAT 20%). After you place an order within a few days, you will receive following documents to your specified e-mail: account on payment and receipt to pay in the bank.

After depositing your payment on our bank account we send you file of the article by e-mail.

To order articles please copy the article doi:

10.14489/td.2022.04.pp.034-039

and fill out the  form  

 

 

 
Rambler's Top100 Яндекс цитирования