Журнал Российского общества по неразрушающему контролю и технической диагностике
The journal of the Russian society for non-destructive testing and technical diagnostic
 
| Русский Русский | English English |
 
Главная Текущий номер
29 | 03 | 2024
2019, 05 май (Mayl)

DOI: 10.14489/td.2019.05.pp.046-051

Коновалов А. М., Кугушев В. И., Яковлев А. Ю.
РЕЗУЛЬТАТЫ КСПЕРИМЕНТАЛЬНОГО ИССЛЕДОВАНИЯ ПРОЦЕССА ПЕРЕРАСПРЕДЕЛЕНИЯ ЭНЕРГИИ СОБСТВЕННЫХ КОЛЕБАНИЙ ПОД ВОЗДЕЙСТВИЕМ ДЕМПФИРУЮЩИХ ФАКТОРОВ
(с. 46-51)

Аннотация. Представлены результаты экспериментальных исследований процесса демпфирования собственных колебаний балки в виде пластины прямоугольного сечения. Исследования проводились с целью продемонстрировать сопровождающий демпфирование процесс перераспределения энергии между формами и гармониками собственных колебаний. Показано, что процесс перераспределения при ограничении возбуждающей энергии обладает большой чувствительностью к демпфирующим факторам. Это позволяет использовать его в качестве индикатора наличия трещин в процессе интегрального неразрушающего контроля деталей и целых конструкций.

Ключевые слова:  собственные колебания, демпфирование, перераспределение энергии колебаний, интегральный неразрушающий контроль.

 

Konovalov A. M., Kugushev V. I., Yakovlev A. Yu.
THE RESULTS OF EXPERIMENTAL STUDIES OF THE PROCESS OF REDISTRIBUTION OF SELF-OSCILLATION ENERGY UNDER THE INFLUENCE OF ATTENUATES
(с. 46-51)

Abstract. Below given are the results of experimental studies of the process of damping of self-oscillation of the beam which is a long plate with rectangular cross-section. The studies were aimed at demonstration of the process (accompanying the damping) of energy redistribution between the modes and harmonics of self-oscillations under the conditions when this energy is essentially bounded. The artificial damper was used which was a small-size slightly pressed plate. The same local damping effect is created by cracks in the parts when there are oscillations, plastic deformation at the apex of crack. Specially developed transducers operating in split mode as part of multifunction acoustic impedance fault detector were used as measuring equipment. The receiver-transducer was attached at the end of the beam, the generator-transducer was attached at the centre of the beam so as to induce oscillation train consisting of five dominant flexural modes of self-oscillations of the beam. Limitation of energy inducing self-oscillations was determined by the rigidity of spring-plates of generator-transducer. The rigidity of the plates was chosen so as oscillation energy was sufficient only for extraction of the given train amplitudes as being dominant, whereas the rest modes of self-oscillations were either not induced at all or were induced with small amplitude. It is demonstrated that redistribution process, when inducing energy is limited, is highly sensitive to attenuants, which allows to use it as a crack indicator during integral nondestructive testing of parts and entire assemblies. For this reason it is concluded that the process of energy redistribution between different harmonics and modes of self-oscillations under the influence of damping factors is advanced for computer-aided nondestructive testing.

Keywords: self-oscillations, damping, redistribution of oscillation energy, integral nondestructive testing.

Рус

А. М. Коновалов, В. И. Кугушев, А. Ю. Яковлев (АО ЦКБ МТ «Рубин», Санкт-Петербург, Россия) E-mail: Данный адрес e-mail защищен от спам-ботов, Вам необходимо включить Javascript для его просмотра. , Данный адрес e-mail защищен от спам-ботов, Вам необходимо включить Javascript для его просмотра. , Данный адрес e-mail защищен от спам-ботов, Вам необходимо включить Javascript для его просмотра.  

Eng

A. M. Konovalov, V. I. Kugushev, A. Yu. Yakovlev (CDB МE Rubin, Sant-Petersburg, Russia) E-mail: Данный адрес e-mail защищен от спам-ботов, Вам необходимо включить Javascript для его просмотра. , Данный адрес e-mail защищен от спам-ботов, Вам необходимо включить Javascript для его просмотра. , Данный адрес e-mail защищен от спам-ботов, Вам необходимо включить Javascript для его просмотра.  

Рус

1. Броек Д. Основы механики разрушения: пер. с англ. М.: Высш. шк., 1980. 368 с.
2. Коновалов А. М., Кугушев В. И., Яковлев А. Ю. Импедансный датчик для неразрушающего контроля жестких металлических конструкций // Контроль. Диагностика. 2019. № 1. С. 32 – 37.
3. Филиппов А. П. Колебания деформируемых систем. Изд. 2-е, перераб. М.: Машиностроение, 1970. 736 с.
4. Гольденблат И. И. Нелинейные проблемы теории упругости. М.: Наука, 1969. 336 с.
5. Ландау Л. Д., Лифшиц Е. М. Теоретическая физика: в 10 т. Т. VII. Теория упругости: учеб. пособие. 4-е изд., испр. и доп. М.: Наука, 1987. 248 с.

Eng

1. Broek D. (1980). Fundamentals of Fracture Mechanics. Moscow: Vysshaya shkola. [in Russian language]
2. Konovalov A. M., Kugushev V. I., Yakovlev A. Yu. (2019). Impedance sensor for non-destructive testing of rigid metal structures. Kontrol'. Diagnostika, (1), pp. 32-37. [in Russian language] DOI: 10.14489/td.2019.01.pp.032-037
3. Filippov A. P. (1970). Oscillations of deformable systems. 2nd ed. Moscow: Mashinostroenie. [in Russian language]
4. Gol'denblat I. I. (1969). Nonlinear problems of the theory of elasticity. Moscow: Nauka. [in Russian language]
5. Landau L. D., Lifshits Е. M. (1987). Theoretical Physics: in 10 volumes. Vol. VII. Theory of elasticity: a textbook. 4th ed. Moscow: Nauka. [in Russian language]

Рус

Статью можно приобрести в электронном виде (PDF формат).

Стоимость статьи 350 руб. (в том числе НДС 18%). После оформления заказа, в течение нескольких дней, на указанный вами e-mail придут счет и квитанция для оплаты в банке.

После поступления денег на счет издательства, вам будет выслан электронный вариант статьи.

Для заказа скопируйте doi статьи:

10.14489/td.2019.05.pp.046-051

и заполните  форму 

Отправляя форму вы даете согласие на обработку персональных данных.

.

 

Eng

This article  is available in electronic format (PDF).

The cost of a single article is 350 rubles. (including VAT 18%). After you place an order within a few days, you will receive following documents to your specified e-mail: account on payment and receipt to pay in the bank.

After depositing your payment on our bank account we send you file of the article by e-mail.

To order articles please copy the article doi:

10.14489/td.2019.05.pp.046-051

and fill out the  form  

 

.

 

 
Поиск
На сайте?
Сейчас на сайте находятся:
 19 гостей на сайте
Опросы
Понравился Вам сайт журнала?
 
Баннер
Rambler's Top100 Яндекс цитирования